25G SPF28 AOC

25G SPF28 AOC





T&S Communication TSSP-8525G-xxxC is a single-Channel, Pluggable, Fiber-Optic SPF28 for 25 Gigabit Ethernet and Infiniband EDR Applications. It is a high-performance module for short-range data communication and interconnect applications that operate at 25.78125 Gbps up to 70 m using OM3 fiber or 100 m using OM4 fiber. This module is designed to operate over multimode fiber systems using a nominal wavelength of 850nm. The electrical interface uses a 20 contact edge-type connector. As a mature AOC factory in China, T&S produces SPF28 Active Optical Cables that are direct-attach fiber assemblies with SPF28 connectors. They are suitable for very short distances and offer a cost-effective way to connect within racks and across adjacent racks.

 

Specifications of 25G SPF28 AOC

 

Absolute Maximum Ratings

Parameter	Symbol	Min	Max	Unit
Storage Temperature	TS	-20	85	℃
Relative Humidity	RH	0	85	%
Case Operating Temperature	TCase	0	70	℃
Supply Voltage	VCC	-0.3	3.6	V

 

 

Recommended Operating Conditions

Parameter	Symbol	Min	Typical	Max	Unit
Case Operating Temperature	TCase	0	-	70	℃
Supply Voltage	VCC	3.13	3.3	3.47	V
Supply Current	Icc	0	-	300	mA
Data Rate	DR	-	25.78125		Gbit/s

 

Transmitter Specification

Parameter	Symbol	Min	Typical	Max	Unit
Input differential impedance	Zin	90	100	110	Ohm
Differential Data Input Swing	Vin	300	-	1100	mVp-p
Transmit Enable Voltage	VEN	-	-	0.8	V
Transmit Disable Voltage	VD	2.0	-	-	V
Average launch power	PAVG	-7.5	-1	+2.5	dBm
Extinction Ratio	ER	2.0	-	-	dB
Center wavelength	λc	840	850	860	nm

 

Receiver Specification

Parameter	Symbol	Min	Typical	Max	Unit
Center wavelength	λc	840	850	860	nm
Differential Data Output Swing	Vout	500	-	800	mVp-p
Bit Error Rate	BER	-	-	10-12
Receiver Overload	Pinmax	2.5	-	-	dBm
Output Differential Impedance	Zout	90	100	110	Ohm
LOS Fault	VOH	2.4	-	-	V
LOS Normal	VOL	-	-	0.4	V

 

Pin Descriptions of 25G SPF28 AOC

 

Pin Definitions of 25G SPF28 AOC

PIN	Symbol	Name/Description
1	VeeT	Transmitter Signal Ground
2	TX_FAULT	Transmitter Fault (LVTTL-O) – Not used. Grounded inside the module
3	TX_DISABLE	Transmitter Disable (LVTTL-I) – High or open disables the transmitter
4	SDA	Two Wire Serial Interface Data Line (LVCMOS – I/O) (same as MOD-DEF2 in INF-8074)
5	SCL	Two Wire Serial Interface Clock Line (LVCMOS – I/O) (same as MOD-DEF1 in INF-8074)
6	MOD_ABS	Module Absent (Output), connected to VeeT or VeeR in the module
7	RS0	Rate Select 0 - Not used, Presents high input impedance.
8	RX_LOS	Receiver Loss of Signal (LVTTL-O)
9	RS1	Rate Select 1 - Not used, Presents high input impedance.
10	VeeR	Receiver Signal Ground
11	VeeR	Receiver Signal Ground
12	RD-	Receiver Data Out Inverted (CML-O)
13	RD+	Receiver Data Out (CML-O)
14	VeeR	Receiver Signal Ground
15	VccR	Receiver Power + 3.3 V
16	VccT	Transmitter Power + 3.3 V
17	VeeT	Transmitter Signal Ground
18	TD+	Transmitter Data In (CML-I)
19	TD-	Transmitter Data In Inverted (CML-I)
20	VeeT	Transmitter Signal Ground

 

Mechanical Specifications of 25G SPF28 AOC

 

Recommended Products

 

Applications

 

Latest News & Blog